Cherne
1-1/2 inch Mechanical Gripper Plug – Hub Sealing for DWV and Test Applications
The1-1/2 inch Mechanical Gripper Plugis engineered for temporary sealing of piping systems during pressure testing, maintenance, or construction staging. Designed for use in hub fittings or open pipe ends, this mechanical plug creates a tight, reusable seal in non-pressurized and low-pressure DWV (Drain, Waste, and Vent) systems.
Product Construction and Functionality
This plug features an expandable rubber gasket and a threaded mechanical fastener, which applies radial compression to the gasket for a secure internal seal. The body is constructed from high-strength plastic or metal depending on the model, and it is suitable for use in horizontal or vertical piping where access and removal are required.
- ✅Mechanical Expansion SealProvides positive engagement in pipe or hub interiors with adjustable compression.
- ✅Corrosion-Resistant MaterialsComponents are designed to resist degradation under standard plumbing environments.
- ✅Tool-Free or Wrench-Tightened InstallationFastening mechanism accommodates either hand-tightening or use of a wrench depending on plug type.
- ✅Reusable DesignAllows repeated use for staging, test cycles, or temporary closure without damage to piping systems.
Technical Specifications
- Nominal Size1-1/2 Inch
- Connection TypeMechanical Compression (expanding gripper plug)
- ApplicationDWV system test sealing, temporary line isolation
- Typical MaterialsThermoplastic body, stainless steel fastener, elastomer gasket (varies by model)
- ComplianceSuitable for use under plumbing code test procedures (not for permanent pressure containment)
Installation Recommendations
Ensure pipe or hub interiors are clean and free of debris prior to insertion. Align the plug squarely within the hub or pipe end and tighten the compression mechanism until resistance is felt and a snug seal is achieved. Avoid overtightening, which may deform the sealing surface or damage the pipe.
Common Applications
Typically used in residential and commercial plumbing systems during DWV testing, line staging, cleanout access, or temporary isolation of unused pipe sections. Compatible with cast iron, PVC, ABS, and other standard hub connections as per fitting type and manufacturer specification.
Application Note
Mechanical test plugs are not intended for permanent installations or for use in pressurized fluid systems unless specifically rated. Always verify compatibility with local codes and test requirements prior to use.
The1-1/2 inch Mechanical Gripper Plugoffers a secure, field-serviceable sealing solution for gravity drain systems, supporting time-efficient testing and installation workflows in accordance with standard plumbing procedures.




