1-1/2″ x 72″ Black Steel Nipple – Threaded Pipe Segment for Gas, Steam, and Water Distribution
The 1-1/2″ x 72″ Black Steel Nipple is a factory-threaded Schedule 40 carbon steel pipe section used to extend, connect, or transition between threaded fittings in mechanical piping systems. Suitable for non-potable applications, it is commonly deployed in gas distribution, steam service, compressed air, and industrial water systems where corrosion protection is not a primary requirement.
This nipple is manufactured from welded or seamless black steel pipe and cut to nominal length with NPT threads on both ends. The black finish offers limited resistance to rust and oxidation during storage and handling, and it is intended for dry, indoor use or systems with corrosion control provisions.
Performance Features
- ✅MaterialSchedule 40 carbon steel pipe, black coated (ASTM A53 or equivalent)
- ✅ThreadingMale National Pipe Thread (NPT) x NPT, per ANSI/ASME B1.20.1
- ✅Nominal Size1-1/2 inch diameter
- ✅Length72 inches (cut length may vary slightly based on threading allowance)
- ✅Temperature RangeSuitable for systems operating up to 650°F (depending on application and sealant used)
Installation Considerations
Apply PTFE thread sealant tape or approved pipe dope to threaded ends prior to installation. Use appropriate torque to prevent over-tightening and preserve thread integrity. Do not use in potable water systems unless corrosion protection and approvals are specified. Verify compatibility with project requirements for pressure class and thermal expansion allowances.
Typical Applications
This fitting is commonly used in
- Natural gas and LP gas distribution systems
- Low-pressure steam and return lines
- Compressed air systems
- Hydronic heating manifolds
- General industrial pipework for fluid transfer
Code and Specification Notes
Black steel nipples are generally manufactured in accordance with ASTM A733 and are typically constructed from A53 Grade A or B pipe. Always verify pressure rating and wall thickness compatibility for critical applications. Not for use in underground applications unless protected per code.
The 1-1/2″ x 72″ Black Steel Nipple provides a reliable, code-aligned solution for extending or connecting piping in threaded systems.Designed for mechanical durability and ease of integration into commercial and industrial piping assemblies.
Specifications
Buying Information
Confirm the listed size and threaded connection details for MPN 587-720HC before ordering.




