1-1/4” x 48” Galvanized Steel Nipple – Extended-Length Threaded Connector for Pressure Systems
This 1-1/4” x 48” galvanized steel nipple is manufactured for use in threaded piping systems where corrosion resistance and mechanical stability are required. With NPT threads on both ends, it provides an efficient method for joining compatible fittings or pipe sections in extended runs, reducing the need for intermediate joints or couplings.
Produced from Schedule 40 carbon steel and hot-dip galvanized to ASTM A153 or equivalent specifications, this nipple is designed to withstand exposure to moisture and moderate corrosive environments. Commonly specified in mechanical rooms, process piping, and utility distribution systems, it is suitable for conveying water, air, or low-pressure fluids in both residential and industrial contexts.
Key Advantages for System Design
- ✅Galvanized CoatingZinc coating provides a barrier against internal and external corrosion, extending service life in wet environments.
- ✅Full-Length ThreadingMale NPT threads cut to ANSI/ASME B1.20.1 standards ensure tight mechanical seals and system compatibility.
- ✅Schedule 40 Wall ThicknessProvides adequate strength for moderate to high-pressure service depending on system design.
Installer-Focused Benefits
- ✅Factory-Threaded EndsReduces onsite fabrication and minimizes thread misalignment or sealing issues.
- ✅Corrosion ResistanceHot-dip galvanized surface treatment is appropriate for indoor and outdoor installation settings.
- ✅Improved AlignmentUseful for long offsets or direct line extensions with minimal joint count.
- ✅Code-Ready MaterialFabricated in compliance with applicable plumbing and mechanical system codes.
Material & Dimensional Specifications
- MaterialCarbon Steel, Hot-Dip Galvanized
- Nominal Size1-1/4” diameter x 48” overall length
- Thread TypeMale NPT (National Pipe Thread), both ends
- StandardThreading to ANSI/ASME B1.20.1; Galvanizing to ASTM A153 (or comparable)
Common Applications
Used in domestic water distribution systems, compressed air lines, and equipment hookups requiring rigid pipe extensions. Frequently installed in utility corridors, service risers, and structural piping layouts where a long, corrosion-resistant threaded section is needed.
Corrosion Resistance Insight
Galvanized nipples are specified when zinc protection is preferred over uncoated steel. They are not recommended for use with potable water systems where long-term zinc leaching may be a concern, unless approved for that specific application by code or engineering spec.
Specifications
Buying Information
Confirm the listed size and threaded connection details for MPN 566-480HC before ordering.




