1/4 inch Stainless Steel 90° Elbow – Fabricated for High-Performance Bends
The1/4 inch Stainless Steel 90 Degree Elbowprovides an efficient directional change in fluid systems while maintaining system integrity. Its 90° bend is ideal for compact installations, allowing for tight turns without compromising flow performance or pressure capacity.
Industrial-Grade Performance
- Corrosion Resistance– Constructed from stainless steel, offering resistance to oxidation and corrosion, particularly in moisture-prone or chemically exposed environments.
- Pressure-Rated Design– Capable of withstanding high-pressure applications common in compressed air, hydraulic, and water distribution systems.
- Full-Port Radius– Reduces pressure drop across the bend, preserving flow characteristics in directional changes.
- Thread Integrity– Female National Pipe Thread (NPT) ends provide a secure, uniform fit for threaded connections, supporting sealing materials such as PTFE tape or anaerobic thread sealants.
Specifications
- Material304 Stainless Steel (or 316, depending on specification)
- Size1/4 inch nominal pipe size
- Connection TypeNPT Female x Female
- Angle90 degrees
- Wall ThicknessConforms to Schedule 40 (unless specified otherwise)
Typical Applications
This elbow fitting is commonly used in the following systems
- Potable water and non-potable water systems
- Hydraulic and pneumatic setups
- Instrumentation lines and gas service piping
- Food-grade and chemical processing (when 316 SS is specified)
Installation Notes
Threaded stainless fittings should be installed using compatible sealants rated for stainless steel. Avoid over-tightening to prevent thread galling. For optimal results, especially in critical systems, torque specifications should be followed according to piping standards.
Compliance & Standards
- ASTM A182 or A403 (based on forged or cast construction)
- ASME B16.11 or MSS-SP-114 for threaded fittings
- NSF 61/372 when rated for potable water use (lead-free variants)
Specifications
Buying Information
Confirm the 1/4 inch configuration, stainless steel material, angle and female x female threaded ends before ordering.




