Lukjan Center End Register Boot — Series P17C, 6″ Ø, 12″ Length, 2-1/4″ Width
Center-end style HVAC register boot that transitions airflow from a 6-inch round duct to a narrow rectangular throat. Ideal for installations where the duct terminates flush with a surface and the grille or register will mount directly to a narrow face opening.
- Series / modelP17C(Lukjan):contentReference[oaicite:1]{index=1}
- Part number / MPNRB102126for the 2-1/4″ × 12″ × 6″ variant:contentReference[oaicite:2]{index=2}
- Nominal duct connection6 inch diameter (round duct)contentReference[oaicite:3]{index=3}
- Boot length (depth)12 inchescontentReference[oaicite:4]{index=4}
- Throat / face opening width2-1/4 inches (2.25″)contentReference[oaicite:5]{index=5}
- Material: Galvanized steel, 30 gauge:contentReference[oaicite:6]{index=6}
- Finish: Hot-dip galvanized:contentReference[oaicite:7]{index=7}
- Weight (approx): 0.50 lb:contentReference[oaicite:8]{index=8}
- Mounting orientation: Center end — air flows into the round duct end, and discharges through a rectangular face (narrow side):contentReference[oaicite:9]{index=9}
- Seam / connection method: Screwed or riveted, sealed with foil tape or duct mastic at joints for air-tightness (standard practice for HVAC register boots)
- Compatibility considerations
- Ensure the grille / register faceplate opening is long enough to cover throat length and at least as wide as 2.25″.
- Check that airflow velocity and pressure drop through the narrow throat are acceptable for your system design.
- Seal all seams and joints to prevent air leakage and maintain system efficiency.
Technical & Performance Notes
- The narrow throat (2.25″) introduces a higher velocity and potential pressure drop — ensure system design accommodates this without excessive noise or restriction.
- Galvanized steel and hot-dip galvanization protect against rusting in indoor HVAC environments.
- At 30 gauge thickness, the boot is moderately rigid but should be handled carefully to avoid dents or deformation during installation.
- Proper alignment with the duct end and register face is critical to avoid turbulence or inefficiency in airflow.
- Use of sealing materials (foil tape or mastic) on seams and edges is strongly recommended to preserve system performance.
Specifications
Buying Information
Confirm RB102126 and the stated dimensions for the existing duct application before ordering




