2 inch Copper Coupling with Stop – Wrought Copper Fitting for ASTM B88 Tube
The 2 inch Copper Coupling with Stop is a solder joint fitting designed for joining two sections of 2 inch copper tube in pressure or non-pressure plumbing systems. Engineered to meet ASME B16.22 and MSS SP-104 specifications, this coupling features an internal dimple (stop) that ensures accurate tube insertion depth and axial alignment during installation.
Manufactured from lead-free wrought copper material in compliance with NSF/ANSI 61 and 372, this coupling is suitable for use in potable water, hydronic heating, chilled water, and other mechanical piping systems. It is designed for use with standard soldering techniques and is compatible with Types K, L, and M hard drawn copper tubing.
Technical Specifications
- ✅Size2 inch nominal (Copper Tube Size)
- ✅Connection TypeSocket x Socket (Solder/Sweat) with Internal Stop
- ✅MaterialWrought Copper (ASTM B75 or equivalent)
- ✅ConformanceASME B16.22, NSF/ANSI 61 & 372, MSS SP-104
- ✅Operating PressureUp to 200 PSI (typical for potable and HVAC systems)
- ✅Temperature RatingUp to 400°F (soldered joint integrity)
Key Performance Features
- ✅Internal StopProvides positive tube positioning, simplifying layout and maintaining proper expansion allowances.
- ✅Uniform Wall ThicknessSupports consistent solder flow and joint integrity under fluctuating pressure and temperature conditions.
- ✅Corrosion ResistanceCopper construction offers inherent resistance to scaling, pitting, and chemical degradation in domestic water and hydronic loops.
- ✅Lead-Free ComplianceMeets Safe Drinking Water Act standards for potable water systems.
Applications
This coupling is used in commercial and residential piping systems where a mechanical, soldered connection is required between two copper tubes of equal size. It is commonly found in domestic hot and cold water distribution systems, recirculating loops, HVAC supply and return piping, and process water lines.
Installation Guidance
Install using standard preparation and soldering practices. Clean the tube ends and fitting sockets, apply approved flux, and assemble with uniform heat distribution to ensure complete solder penetration. Observe all local code requirements for pipe support, expansion compensation, and pressure testing procedures.
Conclusion
The 2 inch Copper Coupling with Stop provides a reliable, code-compliant connection point in copper tube installations. Its internal stop aids in proper tube placement and accelerates layout accuracy, while the lead-free copper construction supports both performance and regulatory compliance. Suitable for use in high-demand potable water and mechanical systems.
Specifications
Buying Information
Confirm the listed size and connection details for MPN PF 10150 before ordering.




