2″ x 3-1/2″ Galvanized Steel Nipple – Threaded Pipe Segment for Corrosion-Resistant Utility Systems
The 2″ x 3-1/2″ galvanized steel nipple is a Schedule 40 pipe segment with male NPT threads at both ends. It is fabricated from carbon steel pipe and hot-dip galvanized to ASTM A153 standards to enhance corrosion resistance in water distribution and general-purpose piping systems. This fitting is used for inline connections where rigid, threaded joints are required in mechanical, commercial, or light industrial applications.
Technical Specifications
- Nominal Size2 inch
- Length3-1/2 inches overall
- MaterialCarbon steel, Schedule 40
- FinishHot-dip galvanized coating per ASTM A153
- Thread TypeNPT (National Pipe Taper), per ANSI/ASME B1.20.1
- Manufacturing StandardASTM A733 (pipe nipple spec), pipe to ASTM A53 Grade A/B
- ApplicationNon-potable water systems, air lines, industrial drainage, and mechanical utility piping
Installation Notes
Use PTFE thread sealant or compatible pipe joint compound on all male threads. Tighten using a pipe wrench sized appropriately for 2″ diameter fittings. Avoid overtightening to maintain thread integrity. Suitable for use in above-ground installations or in enclosures where exposure to moisture is controlled.
Common Applications
Typical uses include
- Cold water distribution in non-potable systems
- Mechanical piping assemblies and equipment connections
- Irrigation and outdoor utility lines (with appropriate protection)
- Air and low-pressure fluid conveyance where galvanized protection is beneficial
Material Consideration
Galvanized steel pipe nipples offer good corrosion resistance in atmospheric and non-aggressive environments but are not suitable for potable water systems unless certified. For systems with acidic or saline conditions, alternate materials such as stainless steel should be considered.




