2″ x 4-1/2″ Galvanized Steel Nipple – Threaded Pipe Fitting for Corrosion-Resistant Piping Systems
The 2″ x 4-1/2″ galvanized steel nipple is a straight, male-threaded pipe segment designed for joining two female-threaded pipe fittings in water distribution, air lines, or general mechanical piping. It is fabricated from Schedule 40 steel pipe and hot-dip galvanized in accordance with ASTM A153 to provide long-term corrosion resistance in non-potable systems.
Product Specifications
- MaterialCarbon steel pipe with hot-dip galvanized zinc coating
- Size2″ NPT nominal diameter x 4-1/2″ overall length
- Thread TypeANSI/ASME B1.20.1 NPT (male x male)
- Wall ThicknessStandard Schedule 40
- Manufacturing StandardConforms to ASTM A733 (for pipe nipples)
- Coating StandardHot-dip galvanized per ASTM A153
- Operating PressureUp to 150 psi, dependent on system design and media
Installation Guidelines
Ensure threads are clean and undamaged before installation. Use PTFE thread sealant or approved pipe joint compound to ensure a pressure-tight connection. Tighten using a properly sized pipe wrench, avoiding overtightening to prevent galling or thread damage.
Typical Applications
This galvanized steel nipple is used in
- Domestic and commercial water supply lines (non-potable)
- Irrigation systems and low-pressure fluid conveyance
- Air compressor piping and mechanical system interconnects
- Outdoor installations where protection against rust is critical
Material Consideration
Galvanized steel offers enhanced resistance to atmospheric corrosion but should not be used in closed-loop hydronic systems or with aggressive water chemistries that may degrade the zinc coating. Not intended for use with potable water unless explicitly certified.




