3/8 inch x 1/2 inch Copper Refrigeration Elbow – Precision-Formed for HVAC and Mechanical Piping Systems
The3/8 inch x 1/2 inch Copper Refrigeration Elbowis a precision-formed wrought copper fitting engineered to transition tubing direction in refrigeration and HVAC line sets. Featuring sweat connections on both ends, this elbow provides a compact 90-degree bend for tight installations while maintaining flow characteristics and minimizing turbulence.
Manufactured from high-purity, lead-free copper, this fitting meets ASME B16.22 specifications and is NSF/ANSI 61 certified for potable water applications. It is suitable for use in low- and medium-pressure refrigeration systems, particularly those using R-22, R-410A, or similar refrigerants in accordance with industry standards.
Advantages for System Designers and Installers
- ✅Accurate Dimensional ToleranceEnsures precise alignment and clean brazed joints
- ✅Thermal and Pressure EfficiencyMade from Type L copper for optimal conductivity and strength
- ✅Reduced Field LaborStreet-compatible profile simplifies layout and reduces extra coupling requirements
- ✅Corrosion-ResistantOffers extended service life in refrigeration environments exposed to moisture and pressure cycles
- ✅Code-CompliantListed for use under major U.S. mechanical and plumbing codes
Technical Specifications
- MaterialLead-free wrought copper (ASTM B75/B88)
- Size3/8 inch x 1/2 inch nominal tubing
- Connection TypeCopper x Copper (sweat/solder joint)
- Bend Angle90 degrees
- CertificationNSF/ANSI 61, ASME B16.22
Application Scope
This elbow is commonly used in refrigerant line sets, chiller systems, evaporator coil routing, and other HVACR applications requiring directional changes in copper tubing. It is also applicable in hydronic systems and general mechanical installations where compact geometry is required for routing efficiency.
Industry Note
Copper elbows in refrigeration applications must be brazed using an appropriate alloy (typically AWS BCuP-5 or BAg brazing alloys) and purged with inert gas to prevent internal oxidation and scale formation. This ensures long-term integrity and system cleanliness.
Installation Guidance
This component is intended for use by trained personnel experienced in copper tube installation. For optimal results, clean all mating surfaces, apply flux where necessary, and follow standard brazing practices. Always pressure-test the assembly per project specifications and applicable codes after installation.
Conclusion
The3/8 inch x 1/2 inch Copper Refrigeration Elbowoffers a dependable solution for HVAC contractors requiring a compact, high-integrity fitting for directional transitions in pressurized copper systems. Built to meet the stringent demands of mechanical applications, it ensures a professional result with every install.
Specifications
Buying Information
Confirm the listed pipe elbow configuration and MPN W 02817 before ordering.





