3 Inch Proflex Flexible Coupling – Cast Iron to PVC/Steel
The 3 inch Proflex coupling is a shielded, flexible transition fitting designed for joining dissimilar piping materials—specifically, cast iron, Schedule 40 PVC, and steel—within non-pressurized DWV (Drain, Waste, and Vent) systems. Engineered to provide a mechanical seal using stainless steel clamps and an elastomeric sleeve, this coupling ensures a secure, leak-resistant joint for both new construction and retrofit applications.
Design and Construction Details
- ✅Stainless Steel Shield– Full 300-series stainless steel band with shear ring provides structural reinforcement and external load distribution.
- ✅Gasket MaterialFlexible elastomeric PVC (meets ASTM C564) ensures long-term sealing under typical DWV service conditions.
- ✅ClampsMultiple worm-drive stainless steel clamps per ASTM C1540 provide uniform compression and corrosion resistance.
- ✅Joint TypeMechanically sealed – does not require solvent welding or threaded engagement.
Applicable Standards and Certifications
This coupling is tested and listed to meet or exceed the following standards for use in regulated drainage installations
- ✅ASTM C1460For shielded transition couplings
- ✅UPC ListedIAPMO certified for use in DWV systems
- ✅CSA B602Certified for use in Canada for sanitary waste applications
- ✅NSF/ANSI 372Lead-free compliance for potable and non-potable systems
Installation Parameters
Install with a calibrated torque wrench per manufacturer guidelines (typically 60 in-lbs per clamp). Ensure both pipe ends are cut square, deburred, and clean. Insert fully into coupling, center at midline, and tighten all clamps uniformly. Not suitable for pressurized applications or direct burial without proper protection.
Typical Use Cases
This coupling is commonly used in DWV system repairs, remodels, and service line upgrades to transition between different materials, such as adapting cast iron soil pipe to PVC or galvanized steel. It is frequently specified in floor slab penetrations, horizontal drainage branches, and building drain reconnections.
Technical Summary
- Nominal Size3 inch
- Pipe CompatibilityCast Iron, PVC (Sch. 40), Steel
- Seal TypeMechanical – Shielded with stainless steel clamps
- ServiceGravity-flow DWV systems only
Code Note
This product satisfies requirements for joining dissimilar materials under the International Plumbing Code (IPC) and Uniform Plumbing Code (UPC), when used in accordance with ASTM C1460 and local jurisdictional standards.
The 3 Inch Proflex Coupling provides a durable, code-compliant solution for connecting non-identical piping materials in gravity-flow drainage applications. Designed for long-term mechanical performance, it simplifies installation and eliminates the need for solvent welding or threading during system transitions.




