4 Inch x 2 Inch PVC DWV Flush Bushing – Solvent Weld Reducing Fitting
The 4 inch x 2 inch PVC DWV flush bushing is a solvent weld fitting designed to reduce pipe diameter within drain, waste, and vent systems. Manufactured for compatibility with ASTM-compliant DWV piping, this fitting enables direct insertion into larger hubs or fittings while maintaining a clean, low-profile transition.
Material and Performance Characteristics
Constructed from rigid polyvinyl chloride (PVC), this flush bushing is suitable for non-pressurized gravity flow systems. It supports high dimensional stability and chemical resistance necessary for sanitary drainage systems
- ✅Schedule 40 DWV RatedCompatible with standard DWV piping per ASTM D2665 or D1785 specifications.
- ✅Solvent Weld ConnectionDesigned for installation using PVC primer and cement, ensuring permanent bonding at the joint.
- ✅Flat-Face DesignAllows full insertion with minimal profile, ideal for vertical stack and offset transitions.
Installation Requirements
Ensure pipe and fitting surfaces are clean, dry, and square-cut. Apply approved primer and solvent cement per manufacturer instructions. Insert the bushing fully into the mating hub and allow for appropriate curing time before system testing. Follow all local code requirements and manufacturer-recommended curing schedules.
Application Scope
Flush bushings are commonly used in residential, multi-family, and commercial buildings for reducing larger-diameter DWV lines to smaller branches. Ideal for use in wall cavities, under-slab installations, and confined chase spaces where traditional reducing fittings may extend too far from the hub.
Code and Compliance Information
This fitting meets applicable plumbing codes requiring the use of lead-free, corrosion-resistant, non-metallic materials in DWV systems. It complies with standards for non-pressure sanitary drainage and is suitable for use in both horizontal and vertical configurations.
Technical Specifications
- MaterialPVC (Polyvinyl Chloride)
- Nominal Sizes4 inch x 2 inch
- Connection TypeSpigot x Hub (Flush Bushing)
- Standards ComplianceASTM D2665, D3311, CSA B181.2
The 4 inch x 2 inch PVC DWV Flush Bushing provides a compact and secure solution for reducing line sizes in solvent-weld DWV systems. Specify for installations where space constraints, code compliance, and long-term durability are key requirements.




