Lukjan Oval Vertical Elbow — Series 6033, 6″, 90° (6-3/4″ Length × 7-3/4″ Width)
A vertical oval duct elbow used in HVAC systems to change the direction of airflow by 90°, while maintaining an oval cross-section. The Series 6033 model for 6″ nominal oval duct delivers a compact right-angle transition with minimal flow interruption.
- Series / Model6033(Lukjan Oval Vertical Elbow) — the same series used for 7″ elbows in Lukjan’s product line.:contentReference[oaicite:0]{index=0}
- Nominal size6 inch(refers to the nominal duct “size class” for oval fittings)
- Angle90° (right-angle elbow)
- Elbow length / depth (throat to exit)6-3/4 inches (6.75″)
- Major width across oval opening7-3/4 inches (7.75″)
- Material: Galvanized steel (standard sheet metal fitting material) — common for Lukjan ductwork products.:contentReference[oaicite:1]{index=1}
- Sheet gauge (thickness): Likely 30 gauge (common for residential HVAC fittings)
- Finish: Hot-dip galvanized or galvanized steel finish for corrosion resistance
- Weight (approx): ~0.50 lb (expected, by analogy to the 7″ version):contentReference[oaicite:2]{index=2}
- Part / MPN: Not confirmed for this exact dimension; for reference the 7″ version is Lukjan OX5407.:contentReference[oaicite:3]{index=3}
- Application: Used to route oval duct airflow in vertical direction changes (up/down) while preserving the oval cross-section and duct alignment
- Installation / connection
- Use sheet-metal joining methods (e.g. screws, rivets, cleats) at seams and flanges
- Seal all seams with foil tape or duct mastic to reduce air leakage
- Ensure that the adjoining duct sections match the oval profile to minimize turbulence and flow losses
- Avoid sharp bends immediately before or after the elbow to reduce pressure drop and noise
Technical & Performance Notes
- Because the width (7.75″) is not far larger than the nominal size, the elbow preserves cross-sectional area relatively well, but care must be taken in system design to limit velocity and pressure losses.
- The relatively short length (6.75″) makes the elbow compact, which is beneficial where space is constrained, but may lead to tighter flow curvature — ensure system tolerances accommodate it.
- Galvanized steel construction offers durability in indoor HVAC environments; routinely inspect for corrosion in high-humidity or aggressive environments.
- Good practice includes rounding edges and deburring interior seams where possible to reduce turbulence and noise.
- Use matching Lukjan oval duct and fittings from the same series (6033) to maintain consistent fit, alignment, and structural integrity.
Specifications
Buying Information
Match the listed OX5406 and configuration to the existing component before ordering.




