Rheem SP21031A OEM Induced Draft Blower Assembly for Residential Powervent Water Heaters
The Rheem SP21031A is a direct replacement induced draft blower designed for use in Rheem, Ruud, and Richmond residential power vent gas water heaters. This factory-authorized blower is responsible for safely managing combustion airflow by drawing exhaust gases through the heat exchanger and expelling them through the vent system. A properly functioning blower is critical to system safety and ignition reliability, particularly in FVIR (Flammable Vapor Ignition Resistant) units.
Component Overview
- ApplicationInduced draft blower for natural gas residential power vent water heaters
- FunctionCreates negative pressure for combustion chamber venting and activates pressure switch for ignition cycle
- Model CompatibilityConfirmed fit for select Rheem, Ruud, and Richmond series water heaters – model-specific verification recommended
Key Features
- OEM ReplacementManufactured to Rheem specifications for performance and fit
- Integrated Motor AssemblyIncludes pre-installed motor, fan wheel, and housing for plug-and-play installation
- Sealed HousingReduces noise and vibration while preventing moisture intrusion into the motor enclosure
- Electrical ConnectorFactory plug compatible with control board harness; no modification required
Technical Specifications
- Part NumberSP21031A
- Voltage120V
- Frequency60 Hz
- MountingDirect mount to water heater top plate via gasket and fasteners
- IncludesBlower motor, housing, and factory-wired harness connector
Installation Notes
Blower replacement requires access to the combustion chamber and proper sealing of the exhaust system. A new gasket (sold separately or with select kits) may be required. Installers should confirm flue clearance, verify electrical connections, and ensure the pressure switch tube is securely fitted. All electrical work must be performed with power disconnected at the source.
Contractor Insights
- Service EfficiencyReduces diagnostic time with integrated OEM assembly—no field adaptation necessary
- Reliable RestartResolves ignition and vent-related shutdowns caused by blower motor failure or mechanical wear
- Code ComplianceMeets UL and ANSI standards for replacement parts in sealed combustion systems
Note to Installers
Installation of the SP21031A should be completed by a licensed technician. Improper handling may result in venting failure, delayed ignition, or control board lockout. Always verify serial number and part cross-reference through official Rheem documentation before replacement.
Specifications
Buying Information
Confirm the listed water heater configuration and model details before ordering.




