1-1/4″ x 18″ Galvanized Steel Nipple – Threaded Pipe Connector for Industrial and Mechanical Systems
The1-1/4″ x 18″ Galvanized Steel Nippleis a straight pipe section with male National Pipe Thread (NPT) ends, fabricated to facilitate inline connections between compatible threaded components in mechanical, plumbing, and hydronic systems. Manufactured to ASTM A53/A733 standards, this nipple is suitable for applications involving potable water (when approved), low-pressure steam, oil, or air systems.
Hot-dip galvanization provides an external zinc coating that enhances corrosion resistance in non-submerged environments. The fitting is machined to ensure thread accuracy and pressure-tight sealing when installed using appropriate joining methods such as PTFE thread seal tape or pipe joint compound.
Product Highlights
- ✅ASTM-Compliant Fabrication– Constructed to meet dimensional and material specifications per ASTM A733 (nipple standard) and A53 (pipe specification).
- ✅Hot-Dip Galvanized– Provides a zinc barrier layer against oxidation and environmental exposure, extending service life in above-ground installations.
- ✅Threaded NPT Ends– ANSI B1.20.1 standard threading ensures compatibility with other Schedule 40 steel or galvanized fittings.
- ✅Schedule 40 Wall Thickness– Suitable for moderate pressure requirements typical of water and air handling systems.
- ✅Uniform Length– 18-inch overall length for use in extended reach pipe runs or spacing requirements.
Recommended Applications
This galvanized steel nipple is commonly used in
- Potable and non-potable water systems (verify local code approval)
- Low-pressure compressed air networks
- Cooling tower and HVAC loop installations
- General mechanical and piping support frameworks
Installation Notes
To ensure system integrity
- Use pipe wrenches or chain tongs suitable for galvanized materials.
- Apply thread sealant compatible with the service medium (oil, water, or air).
- Avoid over-torque to reduce thread deformation or stress cracking of mating components.
Specifications
- Nominal Pipe Size1-1/4 inch
- Length18 inches
- Thread TypeNPT – ANSI B1.20.1
- MaterialCarbon steel, hot-dip galvanized per ASTM A123
- Wall ThicknessSchedule 40
This fitting meets the structural and mechanical demands of professional installations where a corrosion-resistant threaded extension is required. It is not suitable for underground burial without further protection or for high-temperature steam service. Always verify compatibility with fluid media and local code requirements prior to installation.
Specifications
Buying Information
Confirm the listed size and threaded connection details for MPN 566-180HC before ordering.




