Skip to content
Need help identifying a part? Contact parts support
SKU: 1972953Brand: Non-Specified Brand
,

2 inch Copper Cap

$11.33

2 Inch Copper Cap – Solder End, Lead-Free Copper Fitting for Sealing Copper Tube Systems The 2 inch copper cap is a solder (sweat) fitting used to terminate or seal the end of copper tubing in water distribution or hydronic piping systems.

Quantity
SKU: 1972953 Categories: ,

2 Inch Copper Cap – Solder End, Lead-Free Copper Fitting for Sealing Copper Tube Systems

The 2 inch copper cap is a solder (sweat) fitting used to terminate or seal the end of copper tubing in water distribution or hydronic piping systems. It is manufactured from lead-free wrought copper and conforms to applicable ASTM and ANSI standards for use in potable and non-potable applications. This cap is designed for permanent sealing when soldered with approved materials and methods.

Material and Standards Compliance

Constructed from lead-free copper alloy, this fitting complies with NSF/ANSI 61 and 372 for use in drinking water systems. The cap is suitable for use with Type K, L, or M hard or soft copper tubing and meets the requirements of ASME B16.22 and ASTM B75 or B88 (depending on manufacturer specifications). Key characteristics include

  • ✅MaterialLead-free wrought copper
  • ✅ConnectionCup (solder) end, sized to accept nominal 2-inch copper tube
  • ✅Temperature RatingSuitable for service temperatures up to 400°F (204°C) with soldered joints
  • ✅Pressure Rating200–300 psi when properly installed (dependent on tube type and soldering technique)

Installation Requirements

Prepare the tubing and fitting by cleaning and fluxing both mating surfaces. Use lead-free solder and a torch in accordance with ASTM B828. Proper heating and full solder penetration are essential for a pressure-tight joint. Cooling should occur naturally—do not quench with water. Pressure test the assembly after installation to verify system integrity.

Typical Applications

This copper cap is typically installed at the termination point of copper water supply or hydronic piping runs. Common uses include system pressure testing, capping unused lines, or isolating sections during renovations or rerouting. It is also used in DWV systems as a temporary or permanent seal during maintenance procedures.

Code Compliance Note

Use of lead-free fittings in potable water systems is mandated under the Safe Drinking Water Act and enforced through local plumbing codes nationwide. This copper cap is suitable for use in both residential and commercial installations where compliance with NSF/ANSI 61 and 372 is required.

Technical Specifications

  • Size2 inch nominal
  • Connection TypeSolder (sweat) cap
  • MaterialLead-free copper (ASTM B75 or B88)
  • StandardsASME B16.22, NSF/ANSI 61, NSF/ANSI 372

Specifications

Specifications Weight 0.370000 Brand Non-Specified Brand ADA Compliance No Application Potable Water, Hydronic Heating (with Glycol), Chilled Water, Compressed Air (200 psi Max), Non-Medical Gases (140 psi Max), Low Pressure Steam (15 psi Max), Vacuum (24.5 in Mercury Max at 68 deg F) Length (inches) 2.7 Width (inches) 2.55 Height (inches) 2.7 Side A 2″ Fitting Type Caps Item Type Fittings Manufacturer Non Specified Manufacturer MPN PF 07014 Material Copper Product Family Fittings Warranty 50 Years Limited Item Returns This item can be returned

Buying Information

Confirm the listed pipe cap configuration and MPN PF 07014 before ordering.

Brand

Non-Specified Brand

MPN

PF 07014

0
Scroll to Top