2 Inch x 2 Inch x 1-1/4 Inch Carbon Steel Press Reducing Tee – Fuel Gas Rated
The 2″ x 2″ x 1-1/4″ Carbon Steel Press Reducing Tee is a mechanical fitting designed for fuel gas distribution systems using press-connect technology. It enables branching from a 2-inch main line down to a 1-1/4 inch outlet, providing a secure, flame-free installation solution for gas piping in residential, commercial, and light industrial settings.
Performance Characteristics
- ✅Carbon Steel Body– Fabricated from zinc-plated carbon steel for corrosion resistance and high mechanical strength in gas service conditions.
- ✅Press Connection Ends– Compatible with standard press tools and jaw profiles (TH, H, or V), allowing efficient assembly without welding or threading.
- ✅HNBR Sealing Element– Factory-installed yellow hydrogenated nitrile butadiene rubber (HNBR) O-rings provide a gas-tight seal under typical operating pressures and temperatures.
- ✅Branch Reduction– Reducing outlet simplifies pipe size transitions without separate bushings or adapters, reducing potential failure points.
Technical Specifications
- MaterialCarbon steel with zinc-plated coating
- Sizes2″ (main run) x 2″ (main run) x 1-1/4″ (branch)
- Connection TypePress x Press x Press
- Seal MaterialHNBR (yellow) for gas applications
- Operating PressureUp to 125 PSI for fuel gas systems
- Temperature Range40°F to 180°F (with HNBR seal)
- ComplianceANSI LC 4, CSA-certified, ICC-compliant
Intended Use
This reducing tee is used for branching in natural gas or propane systems, including appliance feeds, distribution mains, and zone lines in multi-unit buildings. It supports consistent installation performance across both horizontal and vertical runs in fuel gas configurations.
Installation Guidance
Install using manufacturer-approved press tools and ensure proper pipe preparation, including deburring and calibration. No open flame or threading is required. Verify O-ring condition before pressing and confirm alignment to avoid deformation. This fitting is not intended for potable water systems.
The 2″ x 2″ x 1-1/4″ Carbon Steel Press Reducing Tee is an efficient solution for professionals seeking a reliable, code-compliant gas fitting that minimizes labor while maintaining system integrity.
Specifications
Buying Information
Confirm the listed pipe sizes and connection configuration match the system before ordering.




