3/8″ x 3-1/2″ Galvanized Steel Nipple – Threaded Connector for Pressurized Piping Systems
The3/8″ x 3-1/2″ galvanized steel pipe nippleis a straight, male-threaded fitting used to connect two female-threaded components in fluid or gas transport systems. This nipple is fabricated to meet dimensional and mechanical standards for consistent performance in applications requiring moderate pressure and corrosion resistance.
Manufactured from Schedule 40 carbon steel and protected with a hot-dip galvanized coating per ASTM A153, this component provides extended service life in non-potable water, low-pressure air, and heating line applications. Threads conform to ANSI B1.20.1 NPT specifications, ensuring a secure mechanical seal when installed with proper thread sealant.
Key Features
- MaterialCarbon steel, hot-dip galvanized
- Nominal Size3/8 inch
- Length3-1/2 inches overall
- Thread TypeNPT (National Pipe Taper), male both ends
- Wall ThicknessStandard Schedule 40
- CoatingZinc galvanized for corrosion protection
Installation Guidelines
This nipple should be installed using compatible female-threaded fittings with thread sealant or PTFE tape applied to the male threads. Over-torquing can damage threads or fittings, so torque should be applied using a pipe wrench on the body only—not the threads. System pressure testing is recommended after installation to confirm seal integrity.
Typical Applications
- Low-pressure water distribution lines
- Compressed air service in mechanical or shop systems
- Closed-loop hydronic heating loops (non-potable)
- Industrial systems requiring moderate mechanical strength and corrosion protection
Performance Considerations
- Service PressureSuitable for non-shock pressures up to 150 PSI depending on media and temperature
- Temperature Range20°F to 350°F (-29°C to 177°C)
- ComplianceConforms to ASTM A733 for steel pipe nipples; threading per ASME B1.20.1
Note
Galvanized fittings are not recommended for potable water systems in all jurisdictions due to the potential for zinc leaching and interior corrosion over time. Always verify compatibility with local plumbing codes and media type.
The3/8″ x 3-1/2″ galvanized steel nippleoffers mechanical integrity and corrosion resistance for connections in piping systems where reliability and service longevity are required. Commonly stocked by commercial plumbing and mechanical contractors for use in new construction and maintenance projects.




