P1144 WEST S&D PLUG C/SUNK SPG 4 inch – Termination Fitting for Sewer & Drain Systems
TheP1144 WEST S&D PLUG C/SUNK SPG 4 inchis a purpose-built termination component for 4-inch sewer and drain (S&D) lines. It features a countersunk spigot end, allowing for flush alignment within bell or coupling sockets while providing a watertight seal in gravity flow systems. This plug is designed for use in both permanent and test-point closures where reliable shutoff is critical.
Constructed to perform in subsurface and horizontal applications, this fitting is used at system endpoints, cleanout locations, or unused branches to maintain system integrity and comply with plumbing codes related to wastewater containment and flow control.
Functional Advantages
- ✅Rigid CompositionManufactured for structural reliability in buried installations and vertical stacks.
- ✅Countersunk ProfileAllows clearance for concrete encasement or traffic-rated slab placement where necessary.
- ✅Spigot CompatibilityConnects directly to socket fittings or pipe bells using standard solvent weld or gasket sealing methods.
- ✅Leak PreventionDesigned to eliminate seepage under low-head conditions typical of non-pressurized sewer systems.
- ✅Compliance-ReadyConforms to relevant ASTM and municipal specifications for S&D infrastructure.
Technical Specifications
- MaterialImpact-resistant PVC or equivalent plastic conforming to SDR-35 or similar ratings
- Size4-inch nominal diameter
- End TypeSpigot, with countersunk face
- Usage CategorySewer and drainage systems (non-pressure)
- Code ComplianceTypically meets ASTM D3034 or municipal equivalents
Application Areas
The P1144 S&D plug is typically installed at termination points of stormwater or sanitary piping systems, including cleanouts, dead-ends, and test points. It is frequently used in site development, residential laterals, and sub-grade utility corridors. Its countersunk design ensures minimal interference in confined or slab-adjacent installations.
Industry Note
Properly specified termination fittings are essential to maintaining backflow resistance and preventing ground infiltration at inactive branch lines or maintenance access points. Countersunk spigot plugs are commonly specified in trenching plans and are integral to system inspection and testing protocols.
TheP1144 WEST S&D PLUG C/SUNK SPG 4 inchis a contractor-grade component engineered to meet jobsite requirements for durability, dimensional compatibility, and installation efficiency. It is suitable for inclusion in code-compliant wastewater drainage systems across commercial and residential infrastructure.
Specifications
Buying Information
Confirm the listed plug configuration and MPN before ordering.




