Lukjan Straight Perimeter Register Boot — Series P5, Ø 7″, 12″ Length, 6″ Width
Straight perimeter register boot used in HVAC systems to transition from a round duct to a narrow perimeter opening. The Series P5 boot features a circular inlet and a rectangular (perimeter) face opening, providing efficient airflow delivery along the edge perimeter of a space.
- Series / modelP5(Lukjan Straight Perimeter Register Boot)
- Part / MPN: analogous to **RB202127** variant for 7″ diameter, 12″ length, though that version is listed with 2-1/4″ width.:contentReference[oaicite:0]{index=0}
- Inlet (round duct) diameter7 inches
- Boot length (depth)12 inches
- Face opening width (rectangular / perimeter opening)6 inches
- Material: Galvanized steel (sheet metal construction, typical for HVAC boots)
- Finish: Galvanized coating (resists corrosion in duct environment)
- Gauge / thickness: Typically 30 gauge (common for register boots in the Lukjan product line) — for example, the 5″-diameter variant is listed as 30 ga.:contentReference[oaicite:1]{index=1}
- Weight (approx): ~0.50 lb (based on similarly sized boots):contentReference[oaicite:2]{index=2}
- Design / features
- Perimeter boot — the face opening runs along an elongated slit, delivering air along the edge of a room rather than directly forward.
- Straight, non-adjustable — no directional vanes are included (unless separately added).
- Hemmed collar edges to reduce sharp edges and aid safer handling and finishing.
- Stamp-lock construction to enhance airtightness at seams (common in Lukjan boots).:contentReference[oaicite:3]{index=3}
- Installation / connection
- Insert the round inlet into mating duct or fitting — secure with screws, rivets, or straps.
- Install the perimeter register grille over the face opening, making sure the slit aligns appropriately.
- Seal all seams and joints (foil tape, duct mastic) to minimize leakage and maintain system efficiency.
- Support the boot adequately from the duct or structure to prevent sagging or misalignment over time.
- Performance & considerations
- Because a perimeter boot distributes airflow across an edge, velocity design must ensure consistent flow along the slit length to avoid dead zones.
- The 6″ slit width must be sufficient to allow the required volumetric flow without excessive pressure drop or noise.
- Galvanized steel and moderate gauge thickness ensure practical durability in indoor HVAC environments.
- Edge conditions (trim, grille interface) should be carefully flush and sealed to preserve aesthetic finish and avoid leakage.
Specifications
Buying Information
Verify dimensions and connection details against the listed specifications before ordering.




